Item Number:
PFK-100

PFK-100 Field Meter Set

Range:
High Range 0 V to ± 19.99 KV; least significant digit indicates tens of volts at one inch distance.
Low Range 0 V to ± 1,999 V; least significant digit indicates 1 volt at one inch distance. Measures higher voltages at greater distances, e.g., at two inches double indicated voltage, at four inches multiply indicated voltage by four.

Range Lights:
Red "Bulls Eye" at one inch distance

Accuracy & Environment:
± 2% at ambient conditions ( 23ºF and 30% Rh).
± 5% at 0 - 50ºC and 0 - 85% Rh (non-condensing).
Accuracy unaffected by the presence of air ionization.

Response:
Digital display updates three (3) times per second.
Analog Output Time Constant: Either Range 0.1 sec.
Display Time Constants: High Range 0.2 sec; Low Range 2.0 sec

Controls:
Three position slide switch: KV/INCH - OFF - V/INCH
Sample/HOLD push button, and ZERO adjust knob.

Grounding:
Meter circuit grounded through the conductive case and 10 mm snap fastener mounted on back of case.

Power:
9 VDC alkaline battery. Battery life minimum 40 hours.

Dimensions:
2.4" wide x 4.2" long x .9" deep (1.3" deep with zero knob and snap fastener).

Weight:
5 ounces, with battery

PCS-730 CHARGING SOURCE

Input Power:
9 Volt Alkaline Battery. Battery life in excess of 40 hours continuous operation.

Output:
± 1,000 volts DC Minimum, Current limited to less than 1 Microamp.

Output Connector:
Female banana jack provided with matting contact rod.

Grounding:
10mm female snap fastener on rear of case. Note that wand must be installed and unit grounded for proper operation

Size:
2.5"W x 4"L (4.2"L with jack) x 1.5"D (1.8"D with switch and snap)

Weight:
6 oz (with battery)

CPM-720A CHARGE PLATE ASSEMBLY

Isolated Plate:
Stainless Steel parallel plates, 3.25 inches square. Auxiliary female jack installed.

Capacitance:
Plate Capacitance 10 picofarads (pF) ± 1 pF

Range:
0 to ± 6 KV at a plate separation of 0.60 inch.

Accuracy:
± 2% at 1,000 volts. Calibration adjustment screw provided.

Grounding:
Through conductive case and snap fastener of Model PFM-711A.

Size:
3.25"W x 3.25"L x .9"D (1.0"D with jack).

Weight:
8 oz.